spot measurement

The fluorescent spots were detected by scanning the chromatograms with a CS-9000 Dual Wavelength Flying Spot Scanner. Fluorescence measurement was carried out at 278 nm ( NFLX) and 285 nm ( FLX) as the excitation wavelengths.

试样斑点经薄层色谱扫描仪用荧光法扫描定量，激发波长为278nm（NFLX）和285nm（FLX）；

In this way, the wattless power of the test signal at the head spot of the fault is only needed to sample when the system fault occurs, which simplifies the measurement.

这样，当系统发生故障时，只需采集故障首端测试信号的无功功率，大大地简化了测量的方法。

The influence of knife-edge outline on the spot measurement is discussed and somearein this paper.

本文从理论上分析了刀口的几何特性与物理特性对微小光斑测量的影响.

Three-coordinate measurement of wing-fuselage joints is performed on spot by special machining center.

基于专用数控加工中心实现了在装配现场对翼身接头进行三坐标测量。

Toxicity Measurement of Water Extraction of Castor Bean to Cucumber Spot Disease

蓖麻籽水提物对黄瓜褐斑病菌的生物活性研究

The difference between ideal diffraction pattern and that of actual measurement is considered and the actual diffraction pattern is studied on four aspects, such as white noise, characteristic of Gauss beam of LD,, spatial position and disturbance of thin cylinder and focal spot.

针对细圆柱体理想衍射花样和实测衍射花样的差异，从白噪声、光源的高斯特性、细圆柱体空间位置及外界扰动和焦点光斑等四个方面研究了实测衍射花样。

The stability evaluation and measurement on the spot for large area single junction a-si: h solar cell array

大面积单结a-Si：H太阳电池方阵现场稳定性的评价与测试方法

Focuses on the control methods of key measurement process, include control charts, MSA, period verification, spot check, tour inspection.

论文对测量过程实行三级分类控制，重点论述了对关键测量过程的控制方法，包括控制图法、测量系统分析（MSA）法、期间核查方法，抽查和点检/巡检。

The experiment can observe on comprehensively the model all spot stress situation, can the correct measurement test sample distortion and the stress.

试验能够全面观察模型上所有点的受力情况，能够准确测量出试件的变形和应力。

Based on a lot of spot measurement and trial work, the customary rule of slab design of the heavy plate was modified. Carry out underground and above ground IDO tanks cleaning and leakage inspection for CLP Power in Castle Peak Power Station in 2006.

在大量现场测量与试验基础上修改了工厂原有坯料设计规则.2006年于中电青山发电厂进行地底、地面油缸清理及压力测试工作。

Theoretical study of stray light black spot measurement for optical system

光学系统杂光黑斑测量的理论研究